ENVIRCO Control Console
Operation Manual
5.6.
Option Menu
The option menu allows a user to perform the following functions:
A. Change the access level by entering pass-codes (A1…A3)
B. Select High Speed (normal) or Low Speed (global set back)
C. Adjust the Low Speed set back
D. Select whether pressure switches are present or not
E. Set the speed for every node simultaneously
1. Rotate Select dial to display
“OP” on top LED.
2. Press Select dial to enter option
menu.
1. Rotate Select dial to display
desired option in the center LED.
2. Push Select dial again to exit
option menu.
Figure 5: Option Menu Navigation
5.6.1. Access
Levels
•
Use the Select Dial to display the new access level requested.
•
Press the Select Dial
•
If the new level has fewer privileges, then no pass-code is needed. The
bottom LED will scroll through its seven LED segments to confirm the change
•
If a pass-code is needed, enter the two-number code on the Adjust Dial.
Press the Adjust Dial to lock in the code.
•
If the pass-code is correct, the bottom LED will scroll through its seven LED
segments
5.6.2. Selecting High or Low Speed (HL)
•
This action requires access levels A1-A3
•
Rotate the Select dial to display “HL” in the center LED and press Select dial
to lock in this option.
•
Rotate the Adjust dial to select "HI" or "'LO"
•
If “HI” is selected the units shall run at their individually set speeds
•
If “LO” is selected, each unit will be set back by a global amount (see
adjusting Low Speed below)
•
If Low Speed is selected, this setting will remain in effect until High Speed is
selected or the power is cycled.
Page 11
