OCTO MK2 (71521)
Visit the ENTTEC website for the latest version.
..
USER MANUAL
12
|
ID: 5928937
Document Updated: October 2022
universe and
GB
channels in the seconds universe for a
RGB
LED.
For ease of pixel mapping, ENTTEC recommend offsetting the DMX start address to a number divisible by
the number of channels per pixel. i.e.:
Increments of 3 for RGB (i.e., 1, 4, 7, 10)
Increments of 4 for RGBW (i.e., 1, 5, 9, 13)
Increments of 6 for RGB-16 bit (i.e., 1, 7, 13, 19)
Increments of 8 for RGBW-16 bits (i.e., 1, 9, 17, 25)
Save Settings
: All changes must be saved to take effect. The OCTO MK2 takes up-to 10 seconds to save.
Reset to Defaults
:
This button allows the OCTO MK2 reset back to factory default via web interface. Please
refer to the ‘Reset to Factory Defaults’ section of this document.
Reboot:
Please allow up-to 10 seconds for the device to reboot. When the web interface page refreshes the
OCTO MK2 is ready.
Network Stats
The Network Stats page shows statistics for the input DMX protocol selected.
Art-Net
The information provided is:
Poll packets received
Data packets received
Sync packets received
Last IP where Art-Net packets were received from
Last port data received from
ESP
The information provided is:
Poll packets received
Data packets received
Last IP where ESP packets were received from
Last port data received from
sACN
The information provided is:
Data packets received
Sync packets received
Last IP packets were received from
Last port data received from
