Getting Started
When you power up the ODE for the first time, the default factory profile will
be as follows:
DMX Port
:
It will be set to be an Output by default.
Ethernet Channels:
Out of the box, it will be bound to Universe 0, 0. This is also known as
the first DMX Universe. There are 255 possible DMX over Ethernet universes
from which you can select one. These are also referred to as Streams in the
Node Management Utility.
LEDs
1 Status: This LED will blink when the ODE is operating normally. If the LED
is on and does not blink it means the ODE is in fault, this could be due to a
failed firmware upgrade. You may need to scan your network with NMU and re
flash the firmware.
If the LED off and you have power to the unit please contact ENTTEC support.
2 Port Direction: The LED will be ON when the port is in Output mode and off
when the port is in input mode.
ODE User Manual
9
