Entrust Datacard Retransfer Series, Cleaning Manual, Page: 7 / 13

g
1
2
3
7
4
5
6
8
8
12 527983-001_B
Retransfer Series Printers Cleaning Guide
527983-001_B 13
6. Peel off the center strips on both sides of the adhesive cleaning card.
Leave the side strips in place.
7. Load the adhesive cleaning card in the H2 cartridge and close the
cartridge door (g).
Peel Off Center
Strips Only
Do not insert the adhesive cleaning card in the exception
slide of the multi-hopper.
If the cleaning card appears
bowed, insert it as shown.
Card With Bow
Card Without Bow
Multi-Hopper Printer (cont.) Run the Adhesive Cleaning Card
1. Use the LCD panel to run the adhesive cleaning card.
If you are cleaning a
multi-hopper printer, the
following message displays.
If you are cleaning a single-
hopper printer, the following
message displays.
OR
When the cleaning cycle completes, the adhesive cleaning card is
ejected into the printer reject tray (RT1).
2. Continue with “Prepare the Printer for Use After Cleaning” on
page 14 .
8. Lock the multi-hopper.
d. Rotate the center lock bar to the right to the lock position.
e. Slide the lock bar release button to the right to lock the lock bars
into place.
f. Lock the multi-hopper door lock.
9. Continue with “Run the Adhesive Cleaning Card” on page 13 .