Mechanical installation
18
Issued 2004-12-15
FAA074F0EMEI
8.2
Wall mounted operator with arm system PULL / PULL-P
If the operator is not ordered as an
“operator package with arm system PULL / PULL-P”
the
direction of rotation must be reversed.
8.2.1
Changing the direction of rotation
1
Mount the washers and screws in the drive shaft, one from each side.
2
Dismantle the screws (4 pcs) from the bearing sleeves on both sides.
3
Fit the tools in the holes, one from each side and turn both bearing sleeves simultaneously
approx. 165° until the setting lines in the bearing sleeves are aligned with the setting lines in
the housing.
4
Remount the four screws in the bearing sleeves and dismantle the washers and screws.
(1) Washer and screw
(2) Screw (4 pcs)
(3) Bearing sleeve (2 pcs)
(4) Tool
(5) Setting lines
