Enterasys VHSIM-G6, User Manual

Page: 23 / 44

VHSIM-G6 User’s Guide 2-1
CHAPTER 2
INSTALLATION
To install the VHSIM-G6 you need the following items:
• Phillips screwdriver
• Antistatic wrist strap (shipped with the VHSIM-G6)
• Standoff screws (shipped with the VHSIM-G6)
2.1 UNPACKING THE VHSIM-G6
Unpack the VHSIM-G6 as follows:
1. Remove the VHSIM-G6 from the shipping box. Leave the module in
the antistatic bag until you are ready to install it.
2. Attach the antistatic wrist strap. If the VHSIM-G6 is to be installed in
a standalone device, refer to the instructions on the antistatic wrist
strap package. If the VHSIM-G6 is to be installed in an interface
module, refer to the applicable interface module User’s Guide.
3. After removing the VHSIM-G6 from the antistatic bag, visually
inspect the device. If there is any sign of damage, contact Cabletron
Systems immediately. Refer to
Section 1.5 for instructions. Save the
antistatic bag in the event the VHSIM-G6 must be reshipped.
Only qualified personnel should install or service this unit.
NOTE
Before attempting to use the VHSIM-G6 you should be familiar
with the
IEEE 802.3z specification. The network installation
must meet the guidelines contained in the draft specification to
ensure satisfactory performance.
!
CAUTION
The VHSIM-G6 and the host module or device (platform) are
sensitive to static discharges. Use an antistatic wrist strap and
observe all static precautions during this procedure. Failure to
do so could result in damage to the VHSIM-G6 or host
platform.