Enterasys SecureStack C2, Configuration Manual, Page: 99 / 607

clear tftp retry
SecureStack C2 Configuration Guide 3-45
Example
This example sets the retry count to 3.
C2(rw)->set tftp retry 3
clear tftp retry
Use this command to reset the TFTP retry value to the default value of 5 retries.
Syntax
clear tftp retry
Parameters
None.
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to clear the retry value to the default of 5 retries.
C2(rw)-> clear tftp retry
Clearing and Closing the CLI
Purpose
To clear the CLI screen or to close your CLI session.
Commands
The commands used to clear and close the CLI session are listed below.
cls (clear screen)
Use this command to clear the screen for the current CLI session.
Syntax
cls
For information about... Refer to page...
cls 3-45
exit 3-46