Enterasys SecureStack C2, Configuration Manual, Page: 82 / 607

set inlinepower threshold
3-28 Basic Configuration
Example
This example shows how to display switch PoE properties. In this case, modules in slots 2 and 3
are PoE modules, so their power configurations display:
C2(su)->show inlinepower
Detection Mode : auto
Total Power Detected : 400 Watts
Total Power Available : 250 Watts
Total Power Assigned : 0 Watts
Power Allocation Mode : auto
Power Trap Status : enable
Power Redundancy Status: not redundant
Power Supply 1 Status : Ok
Power Supply 2 Status : Not Installed
Slot Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap
---- ------ -------- -------------- -------- ------------ ----
2 auto 360 0.00 0.00 80 enable
3 auto 360 5.20 1.44 80 enable
set inlinepower threshold
Use this command to set the PoE usage threshold on a specified unit or module.
Syntax
set inlinepower threshold usage-threshold unit-number
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to set the PoE threshold to 50 on module/unit 1:
C2(su)->set inlinepower threshold 50 1
set inlinepower trap
Use this command to enable or disable the sending of an SNMP trap message for a unit or module
whenever the status of its ports changes, or whenever the unit’s PoE usage threshold is crossed.
The unit’s PoE usage threshold must be set using the set inlinepower threshold command as
described on page 3 ‐ 28 .
threshold value Specifies a PoE threshold as a percentage of total system power usage.
Valid values are 11 to 100 .
module ‐ number Specifies the module on which to set the PoE threshold.