Enterasys SecureStack C2, Configuration Manual, Page: 499 / 607

show ip ospf virtual-links
SecureStack C2 Configuration Guide 17-29
Syntax
show ip ospf neighbor [ detail ] [ ip-address ] [ vlan vlan-id ]
Parameters
Defaults
If detail is not specified, summary information will be displayed.
If ip ‐ address is not specified, OSPF neighbors will be displayed for all IP addresses configured for
routing.
If vlan ‐ id is not specified, OSPF neighbors will be displayed for all VLANs configured for routing.
Mode
Any router mode.
Example
This example shows how to use the show ospf neighbor command:
C2(su)->router#show ip ospf neighbor
ID Pri State Dead-Int Address Interface
182.127.62.1 1 FULL 40 182.127.63.1 vlan1
Table 17 ‐ 5 provides an explanation of the command output.
show ip ospf virtual-links
Use this command to display information about the virtual links configured on a router. A virtual
link represents a logical connection between the backbone and a non ‐ backbone OSPF area.
detail (Optional) Displays detailed information about the neighbors, including the
area in which they are neighbors, who the designated router/backup
designated router is on the subnet, if applicable, and the decimal equivalent
of the E ‐ bit value from the hello packet options field.
ip ‐ address (Optional) Displays OSPF neighbors for a specific IP address.
vlan vlan ‐ id (Optional) Displays OSPF neighbors for a specific VLAN. This VLAN must
be configured for IP routing as described in “ Pre ‐ Routing Configuration
Tasks ” on page 15 ‐ 1.
Table 17-5 show ip ospf neighbor Output Details
Output What It Displays...
ID Neighbor’s router ID of the OSPF neighbor.
Pri Neighbor’s priority over this interface.
State Neighbor’s OSPF communication state.
Dead-Int Interval (in seconds) this router will wait without receiving a Hello packet from a
neighbor before declaring the neighbor is down.
Address Neighbor’s IP address.
Interface Neighbor’s interface (VLAN).