Enterasys SecureStack C2, Configuration Manual, Page: 338 / 607

Configuring Priority to Transmit Queue Mapping
10-4 Port Priority and Rate Limiting Configuration
C2(rw)->clear port priority ge.1.11
Configuring Priority to Transmit Queue Mapping
Purpose
To perform the following:
• View the current priority to transmit queue mapping of each physical port.
• Configure each port to either transmit frames according to the port priority, set using the set
port priority command described in “ set port priority ” on page 10 ‐ 2, or according to a priority
based on a percentage of port transmission capacity, assigned to transmit queues using the set
port txq command described in “ set port txq ” on page 10 ‐ 7.
• Clear current port priority queue settings for one or more ports.
Commands
show port priority-queue
Use this command to display the port priority levels (0 through 7, with 0 as the lowest level)
associated with the current transmit queues (0 being the lowest priority) for each selected port. A
frame with a certain port priority is transmitted according to the settings entered using the set
port priority ‐ queue command described in “ set port priority ‐ queue ” on page 10 ‐ 5.
Syntax
show port priority-queue [ port-string ]
Parameters
Defaults
If port-string is not specified, priority queue information for all ports will be
displayed.
Mode
Switch command, read ‐ only.
For information about... Refer to page...
show port priority-queue 10-4
set port priority-queue 10-5
clear port priority-queue 10-6
port ‐ string (Optional) Displays the mapping of priorities to transmit queues for one
or more ports.