Enterasys SecureStack C2, Configuration Manual, Page: 114 / 607

show ciscodp port info
4-8 Discovery Protocol Configuration
show ciscodp port info
Use this command to display summary information about the Cisco discovery protocol on one or
more ports.
Syntax
show ciscodp port info [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, Cisco DP information for all ports will be displayed.
Mode
Switch command, read ‐ only.
Example
This example shows how to display Cisco DP information for Gigabit Ethernet port 1 in slot 1.
C2(su)->show ciscodp port info ge.1.1
port state vvid trusted cos
----------------------------------------------
ge.1.1 enable none yes 0
Table 4 ‐ 3 provides an explanation of the command output.
Timer The number of seconds between Cisco discovery protocol PDU transmissions. The
default of 60 seconds can be reset with the
set ciscodp timer command.
Holdtime Number of seconds neighboring devices will hold PDU transmissions from the
sending device. Default value of 180 can be changed with the
set ciscodp holdtime
command.
Device ID The MAC address of the switch.
Last Change The time that the last Cisco DP neighbor was discovered.
Table 4-2 show ciscodp Output Details (Continued)
Output What It Displays...
port ‐ string (Optional) Displays Cisco DP information for a specific port. For a detailed
description of possible port ‐ string values, refer to
“ Port String Syntax Used in
the CLI
” on page 5 ‐ 2.
Table 4-3 show ciscodp port info Output Details
Output What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“ Port String Syntax Used in the CLI ” on page 5-2.
State Whether Cisco DP is enabled, disabled or auto-enabled on the port. Default state of
enabled can be changed using the
set ciscodp port command.
vvid Whether a voice VLAN ID has been set on this port. Default of none can be changed
using the
set ciscodp port command.