CUSTOMER RELEASE NOTES
08/13/2008 P/N: 9038155-52
Subject to Change Without Notice
Page: 9
of 41
F0615-O
Changes and Enhancements in 5.01.02.0007
Corrected an issue that could result in the inability to apply previously acceptable policies to ports after a
system reboot.
Corrected an issue that prevented proper operation of IGMP Snooping on ports that had authenticated to a
new VLAN.
Enabled the ability to syslog messages greater than 124 Characters in length. Previously some messages may
have been truncated.
Changes and Enhancements in 5.01.01.0051
Corrected an issue in the Enterasys CoS MIB that could prevent new CoS MIB settings from being applied and
enforced from Policy Manager. This issue was originally introduced in the 5.01.01.0047 firmware.
Changes and Enhancements in 5.01.01.0049
Corrected an issue with Bridge MIB that inverted the reading and setting of VLAN tagged egress. Untagged
egress would read as tagged. Tagged VLAN egress would read as untagged. Setting tagged egress would
result in untagged egress. Setting untagged egress would result in tagged egress. This issue was introduced in
the previous release (5.01.01.0047)
Corrected an issue in the display of SNMP configuration that could cause a system reset when the ―show
configu
ration‖ command was issued. This issue was introduced in the previous release (5.01.01.0047)
Changes and Enhancements in 5.01.01.0047
Added Support for CoS MIB based flood control of broadcast, multicast and unknown unicast traffic. (See
Appendix A
of the Release Notes for configuration information).
Added SMON MIB support for management of Port Mirroring. (See
Appendix A
of the Release Notes for
configuration information).
Added support for monitoring resource utilization via the etsysResourceUtilizationMIB.
Corrected a CLI issue that prevented insertion of text without erasing the remainder of the command line.
Corrected a reset issue with the ―show config outfile command‖.
Corrected an issu
e that prevented the clearing of the admin login using the ―clear system login‖ command.
Corrected a display issue in the ―show system utilization process‖ command.
Corrected an issue with counting RMON Statistics for 1024-1518 octet packets.
Corrected an issue with forwarding static multicast addresses after a reset.
Modified the Span Guard port lockout state to disable the port if the spanguardtimeout is set to zero. This will
prevent any control traffic on this port from being processed when locked.
Moved the informational message ―ewaNewConnection EmWeb socket accept() failed:
S_errno_EWOULDBLOCK‖ to the informational level (7) for Syslog.
Corrected a potential loss of Spanning Tree configuration when upgrading from earlier images.
Corrected a C
LI display issue with the ―show inlinepower‖ command when the command is executed over an
SSH session.
Added CLI support for the port string format of type ge.1-2.1.
Corrected an issue migrating policy TCI rule configurations when upgrading system firmware from earlier
images.
Corrected an issue that caused loss of SNMP configuration when restoring a configuration file.
Jumbo packets are now counted as errors when jumbo packets are disabled on the switch.
