Enterasys 08G20G2-08, Hardware Installation Manual

Page: 89 / 96

Torque Values
Enterasys 800-Series Hardware Installation Guide A-11
Torque Values
Table A-10 describes the recommended torque values to use when installing the using standard
threaded fastener machine screws and bolts.
Pluggable Transceiver Specifications
For SFP transceiver specifications, refer to the datasheet at
http://www.enterasys.com/products/transceivers-ds.pdf .
Console Port Pinout Assignments
Refer back to Figure 2-28 on page 2-33 for information about console port pinout assignments.
Regulatory Compliance
This product meets the safety, electromagnetic compatibility (EMC), and environmental
requirements listed in
Table A-11 .
Table A-10 Recommended Torque Values by Screw Size
Screw Size Torque in Pounds Bit Size
English Metric -%5 Nominal +%5
N/A N/A 1.42 1.5 1.57 0
2 – 56 1.5 2.85 3.0 3.15 0
4 – 40 2.5 4.75 5.0 5.25 0/1
6 – 32 3.5 8.55 9.0 9.45 1
8 – 32 4.5 17.10 18.0 18.90 2
10 – 32 5 30.40 32.0 33.60 2
1/4 – 20 6.5 63.65 67.0 70.35 3
Table A-11 Compliance Standards
Regulatory Compliance Standard
Safety UL 60950-1, FDA 21 CFR 1040.10 and 1040.11, CAN/CSA C22.2
No. 60950-1, EN 60950-1, EN 60825-1, EN 60825-2,
IEC 60950-1, 2006/95/EC (Low Voltage Directive)
Electromagnetic Compatibility (EMC) FCC 47 CFR Part 15 (Class A), ICES-003 (Class A), EN 55022
(Class A), EN 55024, EN 61000-3-2, EN 61000-3-3, AS/NZ
CISPR-22 (Class A). 2004/108/EC (EMC Directive)
Environmental 2002/95/EC (RoHS Directive), 2002/96/EC (WEEE Directive),
Ministry of Information Order #39 (China RoHS)