Enterasys 08G20G2-08, Hardware Installation Manual

Page: 42 / 96

Mounting the 8 Port Switches
2-14 Installation
6. Fasten the ends of the Velcro strap securely around the power supply.
7. Plug the DC power cord from the power supply into the switch DC power receptacle that is
appropriate for your type of power supply.
8. Plug the AC cord into the power supply’s AC receptacle.
9. (Optional) Use the wire ties provided to secure the power cords inside the wall mounting tray.
10. Using appropriate screws and the screw holes in each corner edge of the wall mounting tray,
attach the assembled kit to your desired wall location. Secure the assembled unit in place by
positioning the screw holes over the installed wall screws and pulling slightly downward on
the unit.
11. Attach network cables. Refer to “ Connecting to the Network ” on page 2-36 for more
information.
12. Plug each AC power cord into a dedicated, grounded AC outlet.
Installing the Switch in the Lockbox and Mounting on a Wall.
The following section explains how to install the 08G20G2-08 and 08G20G2-08P switches in the
optional lockbox (D2-LOCKBOX) and mounting on a wall.
To assemble the switch and other components in the 08G20G2-08 and 08G20G2-08P lockbox,
proceed as described in the following sections:
• Installing the Switch in the Lockbox .
• Install your power supplies, following the steps in “ Installing the Optional Redundant Power
Supply ” on page 2-15.
• “ Mounting the Lockbox on the Wall ” on page 2-18.
• “ Attaching and Locking the Cover ” on page 2-19.
• “ Removing the Lockbox Cover ” on page 2-20.
Installing the Switch in the Lockbox
To install the switch in the lockbox tray, proceed as follows:
1. Detach the lockbox key and place it in a secure location for later use.