Quick Start User Guide
V1.1
DTEx Land
Series
DT500
|
DT800
|
DT900
INTRODUCTION
The Entel DTEx intrinsically safe series is designed for those users who
demand the ultimate performance for their business critical communications.
Your radio can be configured for Digital or Analogue channels, or both, and to
meet your exact requirements the radio may have been customised by your
Entel Dealer. These features will be explained in a separate guide issued by
the Dealer.
BATTERY INFORMATION
Battery charging
1.
Connect the AC adapter to the charger pod and plug in.
2.
Turn the radio off.
3.
Insert the battery pack into the charger pod, either with or without the radio
attached. The charger LED status light changes to red and charging begins.
4.
When charging is complete the charger LED status changes from red to green.
A fully discharged battery pack will take approximately 3 hours to recharge.
A flashing red LED on the charger indicates there is a problem with the battery.
Remove the battery from the charger and consult your Entel Dealer.
CAUTION
BATTERY PACK PRECAUTIONS
•
Do not recharge the battery pack if it is already fully charged. Doing so may
reduce the life of the battery pack.
•
After charging is complete, remove the battery from the charger. If the power
to the charger is turned off and on again, charging will restart and the battery
will become overcharged.
•
Please ensure that the radio is turned off before placing it in the charger and
never switch a radio on whilst in the charger.
•
Only battery packs and chargers stating they are “Part of IECEx BAS
18.0094X and Baseefa18ATEX0152X” may be used.
•
Do not short the battery terminals or dispose of the battery in a fire.
•
Do not charge the radio and/or battery pack if they are wet.
•
Risk of explosion if battery is replaced by an incorrect type.
•
Dispose of used batteries according to the instructions.
DANGER
DO NOT DISASSEMBLE OR MODIFY THE BATTERY IN ANY WAY!
Your Entel battery pack incorporates a safety circuit to avoid danger. If the safety
circuit is damaged or bypassed, or the battery cells are damaged directly, they
may generate extreme heat, smoke, rupture and emit flames.
REPAIR & MAINTENANCE
Repair and maintenance of this product can only be carried out by Entel. Any
damage to the anti-tamper seal will invalidate the product approval. Should you
have any difficulties in operating this product please contact your Entel Dealer
for support.
OPTIONAL ACCESSORIES
Attaching and removing accessories
To attach an accessory, remove the
accessory cover by unscrewing the
locking screw anticlockwise (leave
cover attached or store in a safe place).
Plug the accessory into the socket,
then carefully tighten the locking screw
clockwise until finger tight (do not over-
tighten or use any implement).
To remove an accessory, unscrew the
locking screw of the accessory by hand
in an anticlockwise direction.
Ensure you refit the accessory socket
cover (the radio is not submersible
without the socket covered).
PACKING LIST
DTxxx
Radio
CSAHT
Rapid charger
CNBxxx
Rechargeable Li-Ion battery
CBHxxx
Spring loaded belt clip
CATxxx
High efficiency antenna
