INVUE CR288 CONCENTRATION MONITOR
15
Installation and Use Manual | Entegris, Inc.
Adjust Temperature Compensation
See
Temperature Compensation
.
DATA LOGGING TAB
Select the
Data Logging
tab to change the parameters
for logging the data.
By default, the software collects one data point every
1.3 seconds and stores the last 5000 data points in
memory for display. The display can show up to 108
minutes of data for each sensor.
Where
1. Put the file location and name into the
Where
box
either manually or by using the
Browse...
button.
File name:
The date and the file name extension
*.csv are automatically added to the file name.
2. Set the number of data points to be stored in each
log file.
NOTE: The default is 10,000 points. The maximum is
64,000 points.
When the data point limit entered is reached, the data
log automatically rolls over to a new file with the
same name originally specified and a new time stamp.
What (Data Set)
1. Select the ports from which to log data.
2. Select the data types to log:
a. Basic data:
• Concentration
• IoR@20
• Fluid temperature
b. All data:
• Concentration
• IoR@20
• Fluid temperature
– Sensor temperature*
– Pixel position
– Index of refraction (IoR)
*Expert mode only.
Figure 20. Data logging tab.
When
1. Select how often data is stored in the data log file:
• Every data point
• 5 seconds
• 10 seconds
• 30 seconds
• Minute
• 5 minutes
2. Check the
Also Save Existing Data
box to continue
storing raw data when averaged data is being
displayed.
3. Enter a time to stop logging data, in hours or
fraction of an hour as a decimal value.
• For continuous data logging, leave the value
at “0.”
4. Press
Start Now
to begin logging.
The program maintains a count of the logged points
on the left side of the screen. This confirms that the
data is being logged.
