10
11
How to install
Product Requirement :
Water pressure should be maintained at a constant rate,
when the water pressure is too low, water cannot flow through the unit.
PE Hose (1/4")
PE Hose (5/16")
Circle nut
Gasket
(installed under
the Faucet)
Alkaline Water
Outlet Adapter
Dust Pre-Filter
To connect the U-Blue faucet
Circle nut
1
2
Use appropriate tools to make 29mm
diameter hole in the location where you will set
up the faucet. Make sure the faucet location
will allow both spouts to reach the sink.
Place the faucet in the hole properly over
the gasket.
3
4
Insert the faucet in the hole and then screw
it with a nut to make it be fixed.
29mm
Harness
1/4” Red color Tube
(Acidic Water)
1/4” White color Tube
(Alkaline Water)
Red color
(Acidic Water)
White color
(Alkaline Water)
Harness
All the fittings are push in style fittings. To attach the hoses to any fitting, firmly insert the end of
the hose into the fitting. Pull firmly to check to connection - you should not be able to pull the
hose out. To release the hose from the fitting, you must push the spring loaded ring protruding
from the end of the fitting while pulling the hose out.
WARNING: incorrect installation could void your valuable warranty
- professional installation is recommended.
After the faucet is fixed, connect it to fitting
with 1/4” hose(for Alkaline) like figure 4.
Check the hose whether it is inserted properly
or not. Also, connect it with 1/4” hose(for Acidic)
like figure 4 and connect the faucet to the body
with connector cord.
Figure 2
Figure 1
Figure 2
Figure 3
Figure 4
Alkaline Water
Outlet Adapter
(Hole size : 5/16”)
Please connect to top cap of the ionizer
for installation Faucet.
Accessories
5/16”
1/4”
1/4”
1/4”
1/4”
1/4”
5/16”
1/4”
Acidic hose
Alkaline hose
