EnStar ENMD Series, Owner'S Manual, Page: 13 / 20

OPERATING INSTRUCTIONS
1 COOLING OPERATION (Operating temperature range: 17 C-32 C/62 F-92 F)
O O O O
- Press the "MODE" button several times until the "COOL" indicator light comes on.
- Press the UP and DOWN buttons " " or " " to select your desired room temperature.
The temperature can be set within a range of 17 C-30 C/62 F-88 F.
- Press the "FAN " and "TURBO " buttons to choose the fan speed.
O O O O
2 DEHUMIDIFYING OPERATION (Operating temperature range: 13 C-32 C/54 F-92 F)
O O O O
- First open the water filling cover at the back of the unit, inside you will find a hose connector. Attach
a section of drain hose(included with the unit) to the connector. Place the open end of the hose
directly over the drain area in your basement floor or in a water container.
- Press the "MODE" button several times until the "DRY" indicator light comes on.
- Under this mode, you cannot select a fan speed or adjust the temperature. The fan motor
operates at Low fan speed. The display will show the actual room temperature.
- Keep windows and doors closed for the best dehumidifying effect.
- Do not put the duct to window.
During Cooling and dehumidifying modes, if the compressor cycle is interrupted
(unplugged, power failure, etc.) and reinstated immediately thereafter, a compressor
protection circuit is automatically self-affected. The compressor cannot operate during
a compressor protection condition. It may take about 3 minutes before the protection
circuit self-deactivates.(This is normal)
CAUTION:
3 HEATING OPERATION (Cooling only type without heat feature)
(Operating temperature range:5 C-30 C/41 F-88 F)
O O O O
- Press the "MODE" button several times until the "HEAT" indicator light comes on.
- Press the "UP and DOWN" buttons " " or " " to select your desired room temperature.
The temperature can be set within a range of 17 C-30 C/62 F-88 F.
- Press the "FAN " button to choose the fan speed.
- Do not put the duct to window.
O O O O
4 FAN OPERATION
- Press the "MODE" button several times until the "FAN " indicator light comes on.
- Press the "FAN button to choose the fan speed. The temperature cannot be adjusted.
- Do not put the duct to window.
"
6 TIMER OPERATION
When the air conditioner is on:
- Press the "TIMER ON/OFF " button will activate the Timer Off setting program. The word OFF and the
clock symbol begin to flash and the LCD display window appears "0.0 " .
- Continue pressing or keep pressing the "UP or DOWN " button to select the time you need the unit
to stop operation. If press UP button, the time is programmed as :0.0- 0.5-1.0-1.5-2.0-2.5-3.0-3.5-4.0-
4.5 -5.0- 5.5-6.0-6.5-7.0-7.5-8.0-8.5-9.0-9.5-10-11-12-13-14-15-16-17-18-19-20-21-22-23-24-0.0.
If press the DOWN button, the time is programmed in reverse order.
For LCD display models:
OPERATING INSTRUCTIONS
12
5 AUTO OPERATION
- Press the "MODE" button several times until the "AUTO " indicator light comes on.
- Under this mode, you cannot select a fan speed. The fan motor operates at Auto fan
speed.
- Do not put the duct to window.
The temperature can be set within a range of 17 C-30 C/62 F-88 F.
O O O O