ENSONIQ KT-76, Musician'S Manual

Page: 195 / 249

Section 10 — Understanding the Sequencer
ENSONIQ KT Musician’s Manual 19
Routing Sounds to Effects in Sequence/Preset Mode
When the KT is in Sequence/Preset mode, the effect for the current sequence/preset or song is
edited by pressing the
{EDIT_SEQ/PRESET}
button, then the upper
{8}
button.
The upper
{8}
button calls up the Effect pages. You can then use the lower
{0}
to
{9}
buttons to
select the various parameters within the Effect pages.
Normally, the different voices that comprise each sound in a sequence are assigned to the three
different busses (as set in the
{EDIT_SOUND}
Output pages). In Edit Track mode, you can
override the voice output routings programmed in each sound.
The available Edit Track Output Bus settings (
{EDIT_TRACK}
, lower
{1}
) are:
• DRY forces all voices to the DRY bus
• FX1 forces all voices to FX1
• FX2 forces all voices to FX2
• VOICE uses normal voice routing as programmed in each sound
• CONTRL-FX uses normal voice routing as programmed in each sound, and routes controller
information from this track to the effect. This is the default setting.
Controllers Routed to Effects
It is sometimes desirable to limit which tracks send controller information to the algorithm. This
is particularly true when transmitting MIDI data on MIDI channels from an external sequencer.
If more than one track is set to CONTRL-FX, “controller fights” can occur. If set to VOICE, the
sound on the track will remain routed to the effects, but its controllers (such as the MOD
WHEEL, PRESSURE, the TIMBRE control, etc.) will not affect the effect.
See Section 8 — Understanding Presets for more information.