ENSA SSL-B Solar Street Light Installation Manual - Version: ENSASSLB-Q219
2
1. Pre-Install Information
Thank you for purchasing a SSL-B Series Solar Street Light.
This install guide covers basic setup, installation and use of your light.
For more information, please visit:
www.ensalife.com
Motion Sensing Solar Panel with Street Light
Note:
This solar panel system is fitted with undervoltage protection, which disconnects the load at
approximately 10.8V(SSL-B50) or 21.6V(SSL-B60). If you are not receiving any voltage on the output
wires, place the panel in direct sunlight for a minimum of one hour and re-test. The output will be
reconnected automatically when battery voltage reaches approximately 11.5V(SSL-B50) or
23.0V(SSL-B60).
Must be installed in direct sunlight. Shade will negatively impact performance.
This solar panel includes a motion-activated LED light. For more information, refer to
4. Solar Panel
LED Configuration
.
•
This product can withstand a class 12 storm. Storms above class 12 may damage the product.
•
The Ingress Protection rating of this product is IP65, which is suitable for outdoor lighting, but
cannot be soaked in water.
•
The solar panel is fragile, do not scratch or break the solar cell.
•
Do not clean the solar panel with an abrasive sponge or soap. Use solar panel cleaning kits.
•
The product contains a Lithium battery - comply with the air transport regulations when shipping,
•
The longest storage period of solar street lamps is 6 months after they are fully charged. If they are
transported or stored for a long time, they need to be checked, recharged otherwise the battery
will be damaged.
•
Charging temperature: 0~60°C. Discharge temperature: 20~60°C
•
Do not store the product in a temperature exceeding 45°C.
1.1 Solar Light Information
