WIRE DIAGRAM:
Do not touch the speaker flex wire
Secure all wiring with wire ties
Properly seal connections to ensure water tight connections
The RGB HUB controller should be installed in a non-metal and dry location
BEFORE INSTALLING THIS PRODUCT:
To avoid potential shorts in the electrical system, be sure to disconnect
the (-) battery cable before installation. Use this unit with a 12-volt battery
and negative grounding only.
Failure to do so may result in a fire or malfunction.
When replacing the fuse, be sure to only use a fuse of the rating specified on
this product.
To avoid short-circuiting, cover any disconnected leads with insulating tape.
It is especially important to insulate any unused wires, which if left uncov-
ered may cause a short circuit. When connecting other devices to this
product, refer to the manual for the product to be connected. The black
cable is ground, make sure to connect the ground wire first.
Ensure that the ground cable is properly connected to metal parts of the
vehicles body frame or direct to the battery if your vehicle does not have a
grounded chassis frame. The ground cable of this unit’s power amp and a
second powered system must be connected to the frame separately with
different screws. If the screw for the ground wire loosens or falls out, it could
result in fire or malfunction.
TOOLS NEEDED:
GROUND CABLE
METAL FRAME
FUSE REPLACEMENT
WITH ATO TYPE ONLY
3 AMP
SPEAKER 1
SPEAKER 2
+
-
+
-
+12V BATTERY YELLOW
REMOTE OUT
+12V BLUE
+12V RED
CHASSIS
GROUND
POINT
BATTERY
OPTIONAL DIRECT BATTERY WIRING CIRCUIT
BLACK
OPTIONAL
FUSE AND FUSE HOLDER
(NOT INCLUDED)
CHASSIS
GROUND
POINT
Recommended 16 ~ 18ga Primary Extension Wire
(not included)
O
N
C
Normally Open
ON/OFF ACC switch
Normally open
ACC switch
(not included)
YOUR
BATTERY
KILL SWITCH
RGB LED 2
RGB LED 1
YOUR RADIO
RGB LED 2
RGB LED 1
SYNC OUT
SYNC IN
RGB SYNC HUB
NOTE: ONLY USE SYNC IN/OUT WHEN CONNECTING
TWO OR MORE HUB SYSTEMS TOGETHER
INSERT
INSERT
RGB LED
EXTENSION WIRE
TO CONNECT MORE THAN
ONE SET OF MRGB65 TOGETHER,
PLUG THE SYNC OUT TO THE SYNC
INPUT OF THE NEXT SYSTEM
STRIPPED WIRE NEGATIVE
12FT
Splice BUTT connectors
3A
CAUTION!!!
Do not ground or short the RGB Wires
EMRGB265W / EMRGB265B
