FLUSH MOUNT INSTALLATION
Tweeter Mounting:
1.
Check for suitable mounting depth.
2.
Mark the center of the spot and cut a 2” diameter hole using a hole saw
or drill bit.
3.
Assemble the cup, clamp and machine screw loosely as shown.
4.
Route wires through the round opening in the bottom of the cup
5.
Press the assembly in the 2” diameter hole until the clamp edge is below
the mounting surface, then tighten the screws.
6.
Connect wires form the tweeter terminals of the crossover to the
tweeteritself. Connect the red wire from the (+) terminal of the crossover
tweeter output to the red (+) wire from the tweeter.
7.
Mount the tweeter by snapping it into the mounting cup.
SURFACE MOUNT INSTALLATION:
Tweeter Mounting:
1.
Using the base of the surface mount cup as a template, mark the
screw-hole and drill them using a ½” drill bit. Drill a second hole for the
speaker wiring using a 3/16” drill bit.
2.
Screw surface mount cup to the panel.
3.
Push the tweeter wires through the open area at the bottom of the cup
and through the hole in the panel
4.
Connect wires from the tweeter terminals of the crossover to the tweeter
wires. Be sure to connect the red wire strand from the tweeter to the (+)
terminal of the crossover tweeter output.
5.
Mount the tweeter by snapping it into the mounting cup.
EC1865BM
INSTALLATION
INSTALLATION
