EnPointe Fencin
g
EP-W01 User Manual
The EP-W01 holds full modular approval. The OEM must
follow the re
g
ulatory
g
uidelines and warnin
g
s listed below to
inherit the modular approval.
ANTENNA INFORMATION
The module has been desi
g
ned to operate with the antennas
listed below.
Note:
the OEM is free to choose another vendor’s antenna of
like type and equal or lesser
g
ain as an antenna appearin
g
in
the table and still maintain compliance. Reference FCC Part
15.204(c)(4) for further information on this topic.
FEDERAL COMMUNICATIONS COMMISSION (FCC)
STATEMENT
You are cautioned that chan
g
es or modifications not
expressly approved by the part responsible for compliance
could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B di
g
ital device, pursuant to part 15 of
the FCC rules. These limits are desi
g
ned to provide
reasonable protection a
g
ainst harmful interference in a
residential installation. This equipment
g
enerates, uses and
can radiate radio frequency ener
g
y and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
g
uarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turnin
g
the
equipment o
ff
and on, the user is encoura
g
ed to try to
correct the interference by one or more of the followin
g
measures:
— Reorient or relocate the receivin
g
antenna
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit di
ff
erent
from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician
for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the followin
g
two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
includin
g
interference that may cause undesired operation
of the device.
FCC RF RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF
exposure compliance. This transmitter must not be co-
located or operating in conjunction with any other antenna or
transmitter. This device is intended only for OEM integrators
under the following conditions:
1. The module may not be co-located with any other
transmitter or antenna.
2. The module must be used with the firmware provided by
EnPointe Fencin
g
Pty Ltd.
Pulse
LSR
W32921B0100
001-0014
Dipole
PIFA
Manufacturer Model
Type
u.FL
u.FL
1dBi
2dBi
Connector
Peak
g
ain
4 of 5