Enovation Controls Murphy EMS PRO LITE, Installation And Operation Manual

Page: 43 / 63

Section 40 00-02-0787
2015-03-23
~ 35 ~
P-
Number
Name Description
P14 CLK C RUN TM This set-point lets you set in the amount of
time you would like your engine to run on
your first start time. You have three available
start times per day (A, B, and C).
Factory
set to 0.0.
P15 CLK C HR
This set-point lets you set the clock hour you
would like to start in 24hr format. For
example, if you want to start in the 3 o'clock
in the afternoon hour, set it to 15.
Factory
set to 00.
P16 CLK C MIN This set-point lets you set the clock minute
you would like to start. For example, if you
want to start at 8:30 in the morning, you
would adjust this until it read 30 in the minute
portion
Factory set to 00.
P17 DISCH PSI @
SHDN
(IF SELECTED)
If Pressure Start/Stop is selected, this shows
what the discharge pressure was when the
controller initiated the last failure shutdown.
P18 LEVEL @ SHDN
(IF SELECTED) If Level Start/Stop is selected, this shows
what the system level was when the
controller initiated the last failure shutdown.
P19 OIL PSI @ SHDN Shows what the engine oil pressure was
when the controller Initiated the last failure
shutdown.
P20 ENG TEMP @
SHDN
Shows what the engine-jacket water
temperature was when the controller initiated
the last failure shutdown.
P21 FUEL LVL @
SHDN Shows what the engine fuel level was when
the controller initiated the last failure
shutdown.
P22 RPM @ SHDN Shows what the engine speed was when the
controller initiated the last failure shutdown.
P23 LAST
SHUTDOWN Shows what caused the last failure shutdown
and the time (in running hours) that it
occurred.
P23 to
P32 ##th
SHUTDOWN P23 to P32 store the 2nd through the 10th
cause of failure shutdown with the date and
time the shutdown occurred.
M-Number Description and Listing
M-0 A Manual EXIT from the S -number setup mode. Press to exit
M1 RS232 Slave This is Modbus slave address for the RS232 port.
Factory set to 1 .
M2 RS485 Slave This is Modbus slave address for the RS485 port.
Factory set to 1 .