OPERATING HEADLIGHT
OPERATING POWER PACKS:
PP2, PP4, & FREESTYLE
1. Fully open the ratchet(s) on the headband before placing the headlight on the
head. See Figure 1.1 for features.
2. Adjust the back knob and top knob (or the Velcro strap) to the correct position
on the forehead so it fits securely and comfortably around the head.
Note: To avoid “headlight headache,” do not over tighten the back knob. The
headlight should fit comfortably, firm but not tight. The weight should rest on
the top of the head.
3. Adjust the circumference by turning the knob(s) to tighten or loosen the ten-
sion.
4. Position the headlamp co-axially (i.e., centered between and in the alignment
with the angle of the eyes). See figure 1.2.
5. Adjust the intensity of the illumination by adjusting the power output on the
Power Pack.
6. Adjust the spot size (like a camera lens) by turning the grip ring on the head-
lamp (excluding fixed spot headlights).
Power Packs should be fully charged before first use or before any long non-used
storage periods. It is recommended to fully charge Power Packs after each use and
avoid partial charges. This is not mandatory but will help keep the Power Packs
life gauge calibrated and in peak operating condition. Batteries will be shipped to
you at 30% charge in accordance with the International Air Transport Association.
1.
Connect the cable with the headlight by firmly inserting the end of the cable
directly into the receptor cable on the headlight.
2. Connect the cable into the Power Pack by inserting the plug into the recepta-
cle located on the side of the Power Pack. To disconnect the cable from the
Power Pack, pull directly out.
Note: Exercise caution when bending, twisting, or folding cables as exces-
sive wear may cause damage to the headlight cable or Power Pack.
3. Press the power button on the Power Pack until the light illuminates (there
will be a beep sound; a 1 – second lag is normal).
• The Power Pack battery life will then be shown on the battery life indicator.
• To increase the light intensity, press the “+” button.
• To decrease the light intensity, press the “-“ button
• To turn the Power Pack “OFF” press the ON/OFF button.
Special Note: The LED indicators on the Power Pack will switch between
the light intensity indicators and battery life indicators.
4. If the Power Pack is turned on but not plugged into the headlight, it will turn
off automatically after 3 seconds. This is a normal, energy-saving feature.
3
Figure 1.2
Figure 1.1
LED Lamp
Adjustment Bracket
Adjustment Knobs