ENOTECNICA PILLAN BACCO 2, Instruction Manual

Page: 7 / 20

Filler BACCO
7
3. TRANSPORTATION
The Filler is shipped completely assembled and packed in a box.
Upon delivery, check that the machine was not damaged during transportation and that you receive all the pieces
indicated in the shipping papers. In case of damage, it is mandatory to tell the carrier and to immediately inform
both the manufacturer and the shipper.
ATTENTION: the vehicles used to move and lift the Filler must be suitable considering its
shape, its dimensions and its mass.
WARNING: Avoid blows and/or pressure on the box.
4. SAFETY
4.1 GENERAL INFORMATION
The aim of the following chapter is to inform operators of possible risks and safety regulations to keep in mind
when using the machine. However, such regulations must be respected in any working environment.
.
4.2 WORKING SAFETY AREA
The working area must be free of any obstacles, so that operators can move freely, and must have adequate
lighting. Also, the following more common norms must be respected:
 comply with the guidelines on the plates on the machine;
 before starting-up the machine, make sure no one is cleaning or performing maintenance on the machine;
 do not perform any cleaning, maintenance or disassembly operation without first disconnecting the machine
from the electrical power network.
4.3 SAFETY INTEGRATED INTO THE MACHINE AND WORKING CYCLE
Working cycle:
The entire working cycle must be controlled by a single operator.
The operator is not exposed to risk if s/he respects:
 the intended use;
 the procedures described in the manual;
 the tasks and competencies that are in keeping with his/her own professional knowledge.
4.4 HAZARDOUS MATERIAL RESIDUES
The Filler is built with materials that do not present danger or risk to operators.
However, if not properly disposed of, the following can be hazardous to the environment, waste products that result
from processing operations and from maintenance operations. These materials must be collected and disposed of
in accordance with the laws that exist in the country where the machine is installed.
4.5 PROTECTION MEASURES AGAINST RISKS DUE TO ELECTRICITY (ONLY MOD. GE)
The drawing of the electrical system in the table and in particular the connection to the source of energy, the
connections to the save-all circuit, the quality and the arrangement of the components
guarantee the prevention of
risks due to electricity.