26
►
SATA Configuration
SATA Controller(s)
Use this item to enable or disable SATA Device.
SATA Mode Selection
Use this item to determine how SATA controller(s) operate.
The optional settings are: [IDE Mode]; [AHCI Mode]; [RAID Mode].
►
PCH-FM Configuration
Use this item to enable or disable Me FM Image Re-Flash fuction.
►
USB Configuration
Legacy USB Support
The optional settings are: [Auto]; [Disabled]; [Enabled].
USB3.0 Support
The optional settings are: [Disabled]; [Enabled].
XHCI Hand-off
The optional settings are: [Disabled]; [Enabled].
EHCI Hand-off
The optional settings are: [Disabled]; [Enabled].
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor.
►
Super I/O Configuration
PS2 KB/MS Connect
