USER MANUAL
EMDCB
–
BLUETOOTH LOW ENERGY MOTION AND ILLUMINATION SENSOR
© 2019 EnOcean | www.enocean.com
EMDCB User Manual | v1.3 | August 2019 | Page 23/67
4.4.1
Static source address mode
By default, EMDCB uses static source addresses meaning that the source address is con-
stant during normal operation. The lower 4 byte of the static source address can be config-
ured (written) via NFC as described in chapter 7.5.
The structure of EMDCB static addresses is as follows:
◼
The upper 2 bytes of the source address are for EnOcean Bluetooth sensors always
set to
0xE500
to enable quick identification
◼
The lower 4 bytes are uniquely assigned to each device. They can be read and
changed using the NFC configuration interface as described in chapter 7.5.
Figure 14 below illustrates the static address structure used by EMDCB.
Figure 14
–
BLE static source address structure
