
9
PAIRING THE REMOTE CONTROL TO THE
ENGLER WARM WATER CIRCULATOR
Pair the remote control to the Engler Warm Water Circulator as follows:
1. Confirm that the remote control unit has fresh batteries.
2. Unplug the power cord of the Engler Warm Water Circulator from the electric outlet.
3. Plug the Warm Water Circulator unit back in, then press the temperature down button (
▼
)
and hold it until numbers appear on the display. This only takes a few seconds. (These
numbers are random and can be ignored.)
4. At the same time press both "Up" and "Down" buttons on the remote control. A temperature
value will appear on the remote’s display and the ” Heating” icon will appear on the screen of
the Warm Water Circulator;
5. Press the ”ON / OFF” button on the Warm Water Circulator to restart it;
6. Press any key on the remote control.
Each remote control can only be paired with one Circulator. To use the remote for another
Circulator, it will be necessary to perform the above steps for that unit as well.