1 Drawer removal
Floor standing models must be fixed to a nog in the wall. Wall hung models must be fixed to two nogs
in the wall. The nog size should be 50 x 75mm.
(a) Open the drawer and carefully lift up on the
end of the drawer to release it from the runner
locator pins. It may be necessary to gently pry
the runner away from the drawer.
(b) The drawer is now only held by the runner
hooks at the back and can be pulled out in
the direction shown.
CONSTRUCTION REQUIREMENTS
INSTALLATION
TOOLS AND MATERIALS REQUIRED - (Not Supplied)
Floor standing models
Wall Hung models
To suit pipework
To suit screws
TOOLS
MATERIALS - Not supplied & must be purchased separately
Fixing washers
20mm
Screws (Refer step 3)
10g x 75mm
50
50
Positioning of the nog near
vertical centre is recommended
however exact position will
depend on plumbing etc.
Locator pin
A height of 800 to 850mm
from the floor to the top of the
vanity top is recommended for
the wall hung vanity.
50mm from top of
cabinet to centre
of nog.
50mm from top of
cabinet to centre
of nog.
800-850
Runner hook
www.englefield.co.nz
Page3
1223207-A02-D October 2021
INSTALLATION INSTRUCTIONS
VALENCIA
TM
Vanity
