INSTALLATION - FINISHED WALL
INSTALLATION - IN-WALL VALVE
1315151-AN2-B July 2017
Page 2
Englefield
1315151-AN2-B July 2017
Page 3
Englefield
STUDIO
Pin Lever Shower or Bath Mixer
INSTALLATION INSTRUCTIONS
STUDIO
Pin Lever Shower or Bath Mixer
INSTALLATION INSTRUCTIONS
NOTE: DO NOT DISCARD THE PLASTIC GUARD UNTIL THE FINISHED WALL HAS BEEN COMPLETED.
1.) Determine where the in-wall valve(1) will be located in the wall.
2.) Construct a suitable nog for mounting the in-wall valve. Ensure the nog is level and at the correct depth.
Note: Distance of the inlet centres from finished wall: 35-60mm.
3.) Ensure the arrow mark(2) on the valve body is pointing up. The hot water inlet(3) is on the left. Fix the
in-wall valve body onto the nog through at least two of the lugs(4). Note: Fixing screws not supplied.
4.) There are two valve connection types available:
Male G1/2”
and
Female Rc1/2”
.
Make sure you have the correct version for your setup and connect the water supply pipes to the
inlets(3)(5)*.
Note:
Hot inlet(3) is on the left, cold inlet(5) is on the right.
5.) Connect pipes from outlet(6)* to shower head or bath spout, as required.
1.) Ensure that all connections are watertight. Remove plastic guard and ensure the cartridge is in the off position.
2.) Turn on the main water supply and check for leaks. Repair as needed.
3.) Replace plastic guard and ensure the main water supply is turned off.
INSTALLATION CHECKOUT
1.) Remove the plastic guard after the finished wall has been completed
2.) Apply a bead of silicone to the rear of the faceplate(8). Slide the faceplate onto the valve body(7). Push it
firmly against the wall.
3.) Install the pin lever(9) on the cartridge and tighten the grub screw(10) with the hex key.
4.) Insert the plug(11) into the handle.
INSTALLATION - TRIM KIT
1.) Install the finished wall up to the plastic guard. Note that the faceplate diameter is 80mm and ensure
an adequate sealing surface is provided.
7
8
9
10
11
1
4
6
2
3
5
4
* Female Rc1/2” valve (Shown)
Male G1/2” valve (Not shown)
