Rear Panel
Fuse:
External mains fuse. For values refer to "technical data".
NOTE:
The value must correspond to the available current.
CAUTION:
Ensure replacement fuses bear identical ratings!
Voltage selector:
This selector must be set to the correct value that corresponds to
the available current, e.g. 120 Volts in the U.S., 220 Volts in
Germany, etc.
CAUTION:
Before you power the amp up, ensure the voltage value set at the
voltage selector corresponds to the available current.
Footswitch:
1/4" jack for connecting a footswitch; it executes
channel selection between Clean and Lead.
Send:
Signal output for the FX Loop. Connect this output to a signal
processor’s input/return jack via a shielded cable with 1/4" plugs.
Return:
Signal input for the FX Loop. Connect this input to a signal
processor’s output/send jack via a shielded cable with 1/4" plugs.
8 Ohms:
8 ohms speaker output jack, the internal 8 ohms speaker
is connected to this jack. You can connect an external 8 ohms
speaker cabinet instead of the internal speaker.
NOTE:
Never operate the amplifier without a sufficient load, otherwise
you may damage or destroy the power amp! Ensure your
cabinet’s specifications match the respective output’s specs.
Technical Data:
rated power:
approx. 30 Watts at 8 ohms.
Tubes:
V1 (Input tube): ECC 83 / 12AX7, FQ selected;
V2, V3: ECC 83 / 12AX7, selected;
V4: ECC 83 / 12AX7, standard;
V5, V6: EL34 matched set.
fused external:
at 230 Volts: 1,25 A
at 100 and 120 Volt: 2,5 A
fused internal:
2 x 1,6 A;
plate fuse:
0,5 A;
CAUTION:
Replace fuses only against same type and rating!
