53 FX Loop II Send
54 FX Loop II Return
55 Balance
Low / High Gain - Volume Ratio Control: Channel 1
57 Low / High Gain - Volume Ratio Control: Channel 2
58 Low / High Gain - Volume Ratio Control: Channel 3
59 Low / High Gain - Volume Ratio Control: Channel 4
Connect this FX Loop II output to a signal processor's input/return jack using the
shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via
the FX Loop I/II (16) button, which switches between these two loops. In the signal
path,
is located post preamp and pre the two power amp Master knobs.
Connect this FX Loop II input to a signal processor's output/send jack using the
shortest possible shielded cord equipped with 1/4" plugs. Activate and deactivate it via
the FX Loop I/II (16) button, which switches between these two loops. In the signal
path,
is located post preamp and pre the two power amp Master knobs.
FX mix control for
. When the knob is set to
, the amp signal is routed
through with no processed signal (0% wet balance) added to the mix. Twist the knob
clockwise to blend in the processed signal (parallel/passive, wet balance 1-99%,
depending on knob position). When the knob arrives at the Effect position, only the
wet signal (that is, the processed signal generated by the connected effect device) is
patched to the power amp (serial, 100% wet).
Set this knob to
when this loop is not in use!
This knob adjusts the balance of volume levels between
in Low Gain mode
and
in High Gain mode. Its setting affects
in High Gain mode only.
The volume level of
in Low Gain mode is determined by the Channel 1
Volume knob (6) setting. Use knob 56 to dial in the relative volume to
in
High Gain mode.
This knob adjusts the balance of volume levels between
in Low Gain mode
and
in High Gain mode. Its setting affects
in High Gain mode only.
The volume level of
in Low Gain mode is determined by the Channel 2
Volume knob (24) setting. Use knob 57 to dial in the relative volume to
in
High Gain mode.
This knob adjusts the balance of volume levels between
in Low Gain mode
and
in High Gain mode. Its setting affects
in High Gain mode only.
The volume level of
in Low Gain mode is determined by the Channel 3
Volume knob (12) setting. Use knob 58 to dial in the relative volume to
in
High Gain mode.
This knob adjusts the balance of volume levels between
in Low Gain mode
and
in High Gain mode. Its setting affects
in High Gain mode only.
The volume level of
in Low Gain mode is determined by the Channel 4
FX Loop II
FX Loop II
FX Loop II
Dry
Dry
Channel 1
Channel 1
Channel 1
Channel 1
Channel 1
Channel 2
Channel 2
Channel 2
Channel 2
Channel 2
Channel 3
Channel 3
Channel 3
Channel 3
Channel 3
Channel 4
Channel 4
Channel 4
Channel 4
NOTE:
56
23
