3.2.1 System
z
Connected to SSID:
Shows the SSID setting in the wireless network.
If it
displays “non-spec”, then the Bridge is not connected to any wireless network.
z
Using Channel:
Shows the channel which the Bridge is using.
z
MAC address of Access Point:
shows
the MAC address of the WLAN card inside
the Access Point.
z
Current transmission rate (M bits/s):
Shows the current transmission
between the connecting AP and the client bridge.
Current communications quality (%):
Shows the Link Quality received from
the Access Point.
(This is not available when using an ad-hoc or point-to-point
connection.)
z
MAC address of the wireless card:
Shows the MAC address of the WLAN card
inside the client bridge.
z
Current IP address:
Shows the IP address of the Bridge
z
Firmware Revision:
Shows the installed version of the firmware.
z
Results of the most recent scan:
Shows the following information of the client
bridge.
SSID
- Shows the current SSID of a network device.
MAC Address
- Shows the wireless MAC address of a network device.
Channel
- Shows the current channel number of a network device.
Signal Strength (%)
- Shows the total available amount of signal measured
above the noise. (This is not available when using an ad-hoc or peer-to-peer
connection.)
Mode
- Displays the operating mode of a network device.
SSID MAC address Channel Signal
strength (%)
Mode
3.2.2 Wireless
z
Operation mode:
Select point to point mode (Ad-hoc) or point to multi-point
