Engel MV7500, User Manual

Page: 16 / 30

Step3: Setup the IR blaster extender cable and IR sensor extender cable
If necessary, connect the Infrared (IR) blaster (or sensor) Extender cable. Users can point hand-held
remote control of your High Definition AV equipment at the Receiver MV7500 or the HDTV set to
operate the source devices, not exceeding the distance of 66 feet at Line-of-sight.
(1) Plug the IR blaster cable into the IR OUT jack of the Emitter MV7500.
Place the IR blaster head near the IR sensor of your High-Definition audio/video devices nearby.
The infrared (IR) sensor should be close to the front panel of your High Definition device, usually behind
dark and sometimes reddish plastic window.
Please try to manually move the IR blaster in the front of the front panel of your HD device and then
press the key of remote control to search a good position of IR response.
When the IR blaster cable is connected, it relays infrared command from your remote control to the
device. Users can control their AV devices by pointing their remote control to the TV of RX instead of to
their AV equipment.
(2) If the Receiver MV7500 will be out of the direct line of sight of your remote controls, plug the IR Sensor
Extender cable into the IR IN jack at the rear panel of the Receiver MV7500 and place the IR sensor on the
front of TV for operation.
Note:
(1) The IR sensor supports 36KHz ~ 56KHz (NEC, RC5, RC6) remote’s signal protocol. Therefore, it is
possible that some devices may not be supported.
(2) The IR blaster supports 47KHz remote’ signal protocol
- 16 -
STICK IR BLA
STER T
O THE FR
ONT OF P
ANEL
OF SOUR
CE EQUIPMENT
.
IR BLAS
TER EX
TENDER C
ABLE
IR SENSOR E
XTENDER C
ABLE
Receiver MV7500
Emitter MV7500