ENFORCER Passive Ethernet Extender over Coax
SECO-LARM U.S.A., Inc.
3
Overview:
BNC Connector
RJ45
Installation:
1.
Determine the location where the units will be placed as well as how much cable will be
required.
2.
Connect one unit to an IP camera or other TCP/IP output device using Cat5e/6 cable of
not more than 6.5ft (2m).
3.
Connect one unit to a DVR, PC or other TCP/IP receiving device using Cat5e/6 cable
Cat5e/6 cable of not more than 6.5ft (2m).
Connect via the Ethernet port found on the front of the Passive Ethernet Extender.
4.
Run a coax cable between the two Passive Ethernet Extenders and connect both ends.
5.
Switch on the IP source (i.e. CCTV camera) and verify that the system is functioning
properly.
Sample Application:
Passive Ethernet Extender
1
NE-SE01-020Q
Coaxial cable
up to 650ft (200m)@10Mbps
**
Cat5e/6 cable
(not more than 6.5ft)
IP Camera
NVR
Passive Ethernet Extender
*
NE-SE01-020Q
*
The passive Ethernet extender units are bidirectional transceivers. It can operate as a transmitter and receiver.
**
Actual transmission range will vary depending on equipment used and cable grade.
Cat5e/6 cable
(not more than 6.5ft)
