ENFORCER 4-in-1 HD TVI, CVI, AHD, Analog Corner-Mount Camera
SECO-LARM U.S.A., Inc.
3
Overview:
Important:
Do not cut DC jack or BNC jack as warranty will be voided.
Installation:
Before Starting:
Camera cover
Security screw
OSD Controller Settings:
To set format via the OSD controller,
press the controller in the direction of
the desired setting, hold for 5 seconds,
and release when the camera restarts.
See chart below.
Direction Format Setting
Up
CVI
Down
TVI
Left
CVBS
Right
AHD
Mounting screws
DC jack Pigtail connector
BNC jack
Joystick
OSD Control
CVI
TVI
(Default)
AHD
CVBS
1.
Run a 12VDC power supply wire and a video cable with
a male BNC connector through the wall at the corner
where the camera is to be mounted.
2.
Do not cut DC jack or female BNC connector as
warranty will be voided. If needed, use the included
pigtail connector.
3.
Use the included security wrench to loosen the screws
and remove the camera cover from the camera.
4.
Connect the power supply and video cable. Turn the
monitor on and make sure the camera is sending the
proper signal.
5.
While watching the monitor, hold the camera against
the corner where it is to be mounted until it is certain
that this mounting location is correct. Use a pencil to
mark the location of the two screw holes.
6.
Disconnect the power supply and video cable.
7.
Mount the camera against the corner using the two
included mounting screws. If the wall is made of dry
wall, brick, or similar material, it may be necessary to
use screw anchors (not included).
8.
Reconnect power and video.
9.
Reattach the camera cover using the included
security wrench.
10.
Do a final test of the video camera and monitor.
1.
Use the camera within given temperature and
electrical limits.
2.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
3.
Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong electrical
signals.
4.
Do not drop the camera or subject it to strong
vibrations.
