ENFORCER 4-in-1 HD Rollerball Cameras (TVI, CVI, AHD, Analog)
SECO-LARM U.S.A., Inc.
3
1.
Use the camera within the given temperature
and voltage limits.
2.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
3.
Do not subject the camera to strong vibrations.
4.
Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
Before Starting:
1.
Run a 12VDC power supply wire and a video
cable with a male BNC connector through the
wall to where the camera is to be mounted.
2.
Loosen the set screws with the included hex
wrench and remove the case from the base.
NOTE: The camera ball is NOT attached to the case
or the base. It sits loose inside the case. Therefore,
be very careful when removing the case from the
base. Do not drop the camera ball.
3.
Mount the base to the wall using the four
included mounting screws. If the wall is made
of dry wall, brick, or similar material, it may be
necessary to use the included screw anchors.
4.
Run the camera’s BNC and power connectors
through the camera base, and connect to the
video and power wires that were run through
the wall.
Installation:
6.
Put the case over the camera ball and onto the base.
7.
Holding the case loosely on the base, turn the camera
ball to the desired direction. Use the included small
screwdriver to adjust the zoom and focus of the camera
ball if needed, via the holes marked “ZOOM” and
“FOCUS” on the top of the camera ball
(EV-Y2201-AMxQ only).
NOTE: Before securing installation, make sure to check both the day
and night images. Adjust the camera ball in a way so that there
are no objects blocking the camera’s view.
8.
Use the OSD controller joystick to adjust camera
settings (see the separate OSD manual).
9.
Once the ball is pointing in the desired direction, tighten
the outer case ring to secure the camera in its position.
10.
Do a final test of the video camera and monitor.
11.
Insert the rubber plugs over the zoom and focus holes
to prevent tampering (EV-Y2201-AMxQ only).
Overview:
Camera ball
Case
Base
Female BNC connector
DC Plug with
terminal block
DC Jack
OSD Controller
EV-Y2201-A2xQ shown above.
Optional Mounting Brackets:
Wall Mount
EV-DWLWQ
Ceiling Mount
EV-DCLWQ
Conduit Box
EV-DSLWQ
Conduit Drop
EV-DDLWQ
OSD Controller Settings:
To set format via the OSD controller, press
the controller in the direction of the desired
setting, hold for 5 seconds, and release
when the camera restarts.
See chart below.
Direction Format Setting
Up
CVI
Down
TVI
Left
CVBS
Right
AHD
Screws (2 shown, use all
4 in installation)
UP
White models shown, gray mounting brackets also available.
