ENFORCER Wall-Plate Camera
SECO-LARM U.S.A., Inc.
3
1.
Please read this manual carefully and keep it for
future reference.
2.
Use the camera within given temperature and
electrical limits.
3.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
4.
Do not mount the camera in areas exposed to radiation,
strong magnetic fields, or strong electrical signals.
5.
Do not open or disassemble the camera. There are no
user-serviceable parts inside.
6.
Do not drop the camera or subject it to extreme shock.
Before Starting:
Mounting the Camera to the Plate:
Changing the Mounting Angle:
Install the angled rubber ring on the front of the plate so
that the camera is tilted. (Approximately 20°)
With a plate and back box
(suggested)
:
With a plate, but no back box:
With no plate and no back box:
Drill a hole in the
wall big enough to
fit the camera.
Mount the plate
directly to the wall.
(See Dimensions.)
Drill a hole in the
wall big enough to
fit the camera. If
mounting to a thick
surface, it may not
be necessary to
use the angled
rings.
(See Dimensions.)
Back box not included.
Mounting Options:
Max. wall thickness:
3
/
4
” (20mm)
BNC connector
Reverse image wire loop*
Plate
Angled rubber ring
12VDC
Note polarity when connecting power
Angled
plastic ring
Camera
IMPORTANT
Do not cut the video or power wires as warranty will be voided.
*To reverse the camera’s image, cut the reverse image
wire loop. To restore the image to default, reattach the
reverse image wire loop. Make sure bare wires are
protected by electrical tape or a similar coating.
Threaded ring
Overview:
If an object installed next to the camera on the wall is
blocking the field of vision, the angled rings may be
installed in front of the wall plate to move the field of
vision forward.
To mount the camera to the plate, position the angled
rings behind the plate, and twist the threaded ring on
to secure the plate to the camera.
Min. wall thickness:
5
/
16
” (8mm)
