ENFORCER Corner-Mount Camera
SECO-LARM U.S.A., Inc.
3
SECO-LARM U.S.A., Inc.
33
3
Installation:
Before Starting:
1.
Use the included security wrench to loosen the screws
and remove the camera cover from the camera.
2.
Run a 12VDC power supply wire and a video cable with
a male BNC connector through the wall at the corner
where the camera is to be mounted.
3.
Temporarily connect the camera to the power supply.
Do not cut DC jack or female BNC connector as
warranty will be voided. If needed, use the included
pigtail connector.
4.
While watching the monitor, hold the camera against
the corner where it is to be mounted until it is certain
that this mounting location is correct. Use a pencil to
mark the location of the two screw holes.
5.
Disconnect the power supply and video cable.
6.
Mount the camera against the corner using the two
included mounting screws. If the wall is made of dry
wall, brick, or similar material, it may be necessary to
use screw anchors (not included).
7.
Reconnect the power supply and video cable. Turn the
monitor on and make sure the camera is sending a
proper signal.
8.
Attach the base cover using the included
security wrench.
9.
Do a final test of the video camera and monitor.
Overview:
Camera cover
Important:
Do not cut DC jack or BNC connector as warranty will be voided.
Pigtail connector
Female BNC connector
DC Jack
Note:
EV-4606 Model shown.
Mounting screw
1.
Please read this manual carefully and keep it for
future reference.
2.
Use the camera within given temperature and
electrical limits.
3.
Do not point the camera at the sun. Heat could damage
the camera, even when not in use.
4.
Do not mount the camera in areas exposed to radiation,
strong magnetic fields, or strong electrical signals.
5.
Do not open or disassemble the camera. There are no
field-serviceable parts inside.
6.
Do not drop the camera or subject it to
strong vibrations.
Security screw
