ENFORCER Vandal-Resistant WDR Dome Camera Manual
ENFORCER Vandal-Resistant WDR Dome Camera Manual
Before Starting
1. Please read this manual carefully and keep it for future reference.
2. Use the camera within given temperature and electrical limits.
3. Do not point the CCTV camera at the sun. Heat could damage the camera, even when not in use.
4. Do not mount the CCTV camera in areas exposed to radiation, strong magnetic fields, or strong
electrical signals.*
5. Do not drop the camera or subject it to strong vibrations.
* NOTE: Many video monitors produce strong electromagnetic fields close to the display CRT,
especially when the monitor is turned on or during de-Gaussing, which occurs
automatically with many monitors when the monitor is turned on.
4
Lens
Power input connector
12VDC/24VAC dual voltage
Video output
connector - BNC
Service monitor
port
Surface mount base
Mounting screws
(Phillips ST4x30)
Flush mount base
Assembly screws
Dome cover ring
Safety strap
Assembly screw
(Torx M4x9)
Dome cover
Camera control board
Alignment mark
Back conduit plug (1”)
Side conduit plug (1”)
(Phillips M4x10)
Camera Assembly
5
Mounting Instructions
1. Remove the dome cover by loosening 3 security screws with
supplied Torx wrench.
2. Mount the camera to ceiling or wall.
A. If surface mounting, see figure 1.
B. If flush mounting, see figure 2.
C. If mounting to electrical box, see figure 3 and 4.
Figure 1 - Surface Mount
Figure 2 - Flush Mount
A. Use Guide Pattern on wall or ceiling.
B. Using four ST4x30 screws, mount surface base
to a sturdy surface.
C. Using four M4x10 screws, affix flush mount
base to surface base.
A. Use Guide Pattern on wall or ceiling.
B. Using four ST4x30 screws, affix flush mount
base to a sturdy surface.
Plastic
anchors
(if needed)
ST4x30
MX4x10
Torx M4x9
UNC 8-32x0.75
(not included)
1” electrical
conduit
UNC 8-32x0.75
(not included)
ST4x30
Figure 3 - Mounting to Electrical Junction Box
(with surface mount base)
Figure 4 - Mounting to Electrical Junction Box
(flush mount)
