ENFORCER Mini Bullet Camera
SECO-LARM U.S.A., Inc.
Installation:
1.
Please read this manual carefully and keep it for
future reference.
2.
Use the camera within given temperature and
electrical limits.
3.
Do not mount the camera in areas exposed to
radiation, strong magnetic fields, or strong
electrical signals.
4.
Do not point the camera at the sun. Heat could
damage the camera, even when not in use.
5.
Do not open or disassemble the camera. There
are no field-serviceable parts inside.
6.
Do not drop the camera or subject it to
strong vibrations.
Before Starting:
1.
Run a 12VDC power supply wire and a video
cable with a male BNC connector through the
wall to where the camera is to be mounted.
2.
Temporarily connect the camera to the power
supply.
Do not cut DC jack or female BNC
connector as warranty will be voided.
If needed, use the included SECO-LARM
DC plug with terminal block.
3.
Connect the BNC connector to a test monitor.
4.
While watching the monitor, hold the camera
against the wall by hand where it is to be
mounted, then turn the camera until it is certain
that this mounting location is correct.
5.
Use a pencil to mark the location of the three
screw holes in the mounting plate.
6.
Disconnect the power supply and video cable.
7.
If alternate mounting is desired, remove the
bracket by loosening the bracket screw. Attach
the bracket to the back of the camera.
8.
Mount the mounting plate to the wall using the
three included mounting screws. If the wall is
made of dry wall, brick, or similar material,
it may be necessary to use screw anchors
(not included).
9.
Reconnect the power supply and video cable.
Turn the monitor on and make sure the camera
is sending the proper video signal.
10.
Adjust the camera angle using the adjustment nut.
11.
Do a final test of the video camera and monitor.
Overview:
Mounting holes
Important:
Do not cut DC jack or female BNC connector as warranty will be voided.
Camera
Sunshield
Adjustment nut
Female
BNC connector
DC jack
Mounting bracket
DC plug with
terminal block
3
Remove the base from the bottom by twisting the bracket
screw. Attach the base to the back of the camera.
Alternate Mounting Method
Bracket screw
