ENFORCER
24
LED
CCD
IR
D
AY
/N
IGHT
C
AMERA
M
ANUAL
1.
Run a 12VDC power-supply wire and a video cable
with a male BNC connector through the wall to where
the camera is to be mounted (if necessary).
2.
Assemble the mounting bracket; then screw it into the
back of the camera. Tighten the adjustment nut.
3.
Temporarily connect the camera to the 12VDC power
supply.
Do not cut DC jack or female BNC
connector as warranty will be voided. If needed,
use the included SECO-LARM DC plug with
terminal block.
4.
Temporarily connect the camera’s female BNC
connector to the video cable’s male BNC connector.
5.
While watching the monitor, hold the camera bracket
by hand against the wall where it is to be mounted,
then twist the camera until it is certain that this
Installation:
mounting location is correct. Use a pencil to mark the
location of the three screw holes in the bracket.
6.
Disconnect the 12VDC power supply and video cable.
7.
Mount the bracket to the wall using the three included
mounting screws. If the wall is made of drywall, brick, or
similar material, it may be necessary to use the three
included screw anchors.
8.
Reconnect the 12VDC power supply and video cable.
Turn the monitor on and make sure the camera is sending
the proper video signal.
9.
To adjust the camera angle, loosen and tighten the
bracket’s thumb screw. Turn the camera and change its
angle relative to the bracket until the desired scene is
displayed.
10.
Do a final test of the video camera and monitor.
1.
Please read this manual carefully and keep it for
future reference.
2.
Use the camera within given temperature and
electricity limits.
3.
Do not aim the LED light directly at the eyes when the
LEDs are on.
4.
Do not point the camera at the sun. Heat could damage
the camera, even when not in use.
5.
Do not mount the camera in areas exposed to radiation,
strong magnetic fields, or strong electrical signals.*
6.
Do not open or disassemble the camera. There are no
field serviceable parts inside.
7.
Do not drop the camera or subject it to strong vibrations.
*Note:
Many video monitors produce strong
electromagnetic fields close to the display CRT,
especially when the monitor is turned on or during
de-gaussing, which occurs automatically with
many monitors when the monitor is turned on.
Before Starting:
Important:
Do not cut DC jack (F) or
female BNC connector (G)
as warranty will be voided.
Overview:
A.
Camera
B.
Adjustable sunshield
C.
Mounting bracket
Important:
Do not remove label or
open case as warranty
will be voided.
A
B
C
D
F
F
E
H
Connect to video
cable’s male
BNC connector
I
G
G
D.
36” (0.9m) cord
E.
Thumb screw
F.
DC jack
I.
Female BNC
connector
(video out)
G.
Adjustment nut
H.
DC plug with
terminal block
