ENFORCER Enhanced HDMI
®
Extenders over Single Cat5e/6
SECO-LARM U.S.A., Inc.
3
Overview:
Back View
Front View
MVE-AT11-01NQ
Top View
Front View
MVE-AT11-W1NQ
Top View
Installation:
1.
Determine where the transmitter and receiver will be wired as well as how much Cat5e/6 cable
will be necessary.
2.
Connect the HDMI cable to both the transmitter and the source device.
3.
Connect the HDMI cable to both the receiver and the display.
4.
Connect the Cat5e/6 cable to both the receiver and transmitter units.
Note
: For best results, use Cat6 cable.
5.
Connect one 5VDC adapter to the transmitter and another to the receiver.
6.
Determine which device, if any, will be controlled by the remote control. Install the IR
transmitter to the IR-TX port of the closest extender unit, pointing the IR transmitter at the
device. Install the IR receiver to the IR-RX port of the other extender unit. Point the remote
control at the IR receiver when in use.
7.
MVE-AT11-W1NQ Only:
Install the MVE-AT11-W1NQ using a standard double-gang box.
8.
Switch on the HDMI source and display to verify that the system is functioning properly.
Steady ON
Flashing
OFF
Active
N/A
Unit is working
Unit is not
working/powered
Link
Connection OK
Check connection
Not connected
HDCP
Video has HDCP
Video does not have
HDCP
No video
Power
Power ON
Check power
Power OFF
4
5
/
16
”
7
/
8
”
Status LED Chart:
Status LEDs
Status LEDs
HDMI Port
HDMI Port
5VDC
Power input
RJ45 Port
5VDC
Power input
IR Adapter ports
IR Adapter
ports
Parts List
1 x Transmitter
1 x Receiver
2 x 5VDC Power adapters
1 x IR Transmitter
1 x IR Receiver
1 x Manual
4
1
/
2
” (114mm)
4
9
/
16
”
(116mm)
1
5
/
16
”
(34mm)
Extender for HDMI over Cat5e/6
2
15
/
16
”
(75mm)
www.seco-larm.com
Please use T568-B wiring standard.
Extender for HDMI over Cat6e/6
HDMI In
Note:
Only transmitters are shown above. The transmitters and receivers have the same dimensions and similar parts.
