ENFORCER Voice Dialer
SECO-LARM U.S.A., Inc.
11
Dialer will not dial out
•
Ensure sure that the telephone line is working and is firmly connected to
the correct terminal on the dialer.
•
Make sure that you have programmed at least one telephone number into
the unit and that the full number has been stored.
Unit doesn’t respond to a
call-back
•
Check to see if another unit (fax or answering machine) could be
answering the call and remove the other unit.
•
Adjust the call-in ring detect setting so the dialer will answer.
Difficulty in activating
'listen in' by telephone
remote control
•
Try pressing the code key again.
•
Move to a quieter location as ambient noise may affect the dialer’s ability
to detect the tone signal.
REMOTE CONTROL BY USER CALL-IN (CALL BACK)
The user can dial in to perform the actions below remotely. To do so:
1.
Using a mobile phone or any touch-tone (DTMF) phone, dial the phone number that the voice
dialer is connected to. The voice dialer will answer and “beep” once after the number of rings
set for remote access (see
Setting the Number of Rings for Remote Access
, pg. 9).
2.
Enter the PIN Number on the phone’s keypad. You will hear a "beep" sound if the correct code
has been entered. If a wrong code is entered, the dialer will disconnect automatically and the
user must dial in again. If there is no key entry within 20 seconds, the dialer will hang up.
3.
Press one of the following function codes to control the system remotely and press a second
code within 10 seconds for another function.
Function
Code
Start listening in for 30 seconds, press code again to continue listening
4
Activate the auxiliary output for the set time
8
Trigger or stop the auxiliary output
9
Viewing the Last Event
To view the last event, in setup mode:
1.
Press the UP or DOWN button until you see "06 Last
Event" on the display, or press 06 on the keypad.
2.
Press the ENTER button and the last event will be shown.
The example to the right shows that input 1 was triggered,
causing the dialer to dial 555-555-1212.
3.
When finished, press the ESC button to return to the settings menu to program other functions.
4.
Press the ESC button again to exit the setup mode.
Resetting the Dialer
Resetting the dialer deletes
all settings and data
. To reset, disconnect the power and then power
up while holding down the ENTER button until you hear a single long beep.
Operating the Voice Dialer (Continued):
Menu(1-12)
06 Last Event
Trigger IP-1
5555551212
Troubleshooting:
