ENFORCER VIDEO DOOR PHONE
6
Installation (camera):
Direct
Sunlight
Rain
Snow
Figure 6 – Rear of
Camera Unit
Tilt Adjustment
Figure 5 – Camera and
Mounting Bracket
The tab on top of the
camera slides in first.
Secure the camera to the bracket
with the hidden camera screw
underneath this slide-out cover.
5’
(150 cm)
1. Position the camera so the area to be monitored is
easily visible, typically 5 feet (150cm) above the
ground (see Figure 3). Do not position the camera in
direct sunlight or where it will be exposed directly to
rain or snow.
2. Cut a hole large enough to run the 22AWG 4-
conductor wire through the wall to where the camera
unit is to be mounted. If using a locking device, the
wires used to control the device must also be run
through this hole.
3. Run the 22AWG 4-conductor wire from the camera
location to where the monitor is mounted. The
maximum wiring distance is 165’ (50m) (see Wiring
Diagram, page 8).
4. Using the 4 included screws and 4 screw anchors,
attach the camera mounting bracket to the wall (see
Figure 4).
5. Connect the wires coming from the monitor to the
proper terminals E1 thorough E4 on the back of the
camera (see Figure 5).
6. If the Door Phone will control a locking device,
connect the wires coming from the locking device to
the relay output terminals K1 and K2 on the back of
the camera (see the Sample Application on page 11).
7. Set the desired camera angle up and down by
moving the tilt adjustment in the opposite direction.
8. Push the tab on top of the camera into the top of the
bracket. Make sure that no wires are preventing the
camera from seating properly in the bracket. Pull the
slide-out cover to expose the hidden screw location.
9. Secure the camera to the mounting bracket with the
included camera screw. Close the cover at the bottom
of the camera to conceal the camera screw.
Figure 4 – Camera
Mounting Location
SECO-LARM U.S.A., Inc.
E1
E2
K1
E3
K2
E4
Model:
DP-121CQ
Video Door Phone
05A08
PICCN2
Camera
ENFORCER VIDEO DOOR PHONE
7
Operating Instructions:
1. When the request-to-enter button on the camera
is pressed, the monitor will ring twice. After
ringing, any connected monitors will switch on.
2. When the handset is picked up, audio can be
heard through the handset.
NOTE: If two monitors are connected, the monitor
that does not answer the call will turn off.
3. If an additional camera is installed,
pressing
the Camera Button will switch the image
displayed on the monitor to the view from the
other camera. Pressing the camera button again
will turn off the cameras.
4. The monitor is automatically switched off after the
handset is hung up, 1 minute of inactivity pass, or
the Camera Button is pressed.
See the Wiring Diagram on Page 8 for more details.
To allow access to the entrance, press the Unlock
Button. This signals the door strike or lock to allow
entry.
IMPORTANT:
The door strike or lock will only
remain unlocked while the Unlock
Button is pressed.
For Example:
If the entrance door is located a few steps from
the camera, the Unlock Button must be pressed
long enough to give the visitor enough time to
open the entrance.
Ring
Ring!
Camera Button
Unlock Button
If connected to a door strike or
other locking device:
SECO-LARM U.S.A., Inc.
