ENFORCER 300C/L
Owner's Manual
Page 5
When you press button #1 to arm the alarm,
and the alarm responds with three chirps and
three light flashes, there are two possibilities:
A. Delayed domelights If your domelights
do not immediately turn off when you
close your car door (in other words, your
vehicle has delayed domelights), this is
normal. The alarm should protect all the
openings once the domelights go off.
B. A zone was bypassed In other words,
the alarm has armed, but a hard wired
door is not protected (either because it is
open, or because its pin switch is broken).
ZONE BYPASS
If the bypassed door is later closed, it will
be restored (no siren chirp or light flash).
If your alarm indicates a bypassed zone, find
the cause as soon as possible to ensure your
vehicle is completely protected. For instance,
if your driver's door is not properly closed
when you arm your alarm, a thief could open
any door without setting off the alarm.
NOTE The three zone bypass confirm
chirps will not sound if chirp delete is
engaged. However, the parking lights will still
flash three times. See CHIRP DELETE, page 7.
SENSOR BYPASS
This is useful if you know, based on
experience, that your shock, glass break, or
other add on sensor will false trigger, such as
when you park near a construction site.
To bypass your alarm's sensors, first press
button #1 to arm the alarm (even if the alarm
is set for passive arming). The siren chirps
and the parking lights flash once (three times
if a zone is bypassed) to confirm armed.
Within three seconds, press button #2. The
siren chirps three times and the parking lights
flash three times to confirm sensors are
bypassed. The sensors are automatically
restored the next time button #1 is pressed.
→
→
→
→
To trigger the alarm in an emergency (armed
or disarmed), press and hold transmitter
button #1 for 3 seconds. The siren sounds
and the parking lights flash about 30
seconds. You can also stop the siren and the
EMERGENCY CALL FOR HELP (Panic)
parking lights by pressing
button #1 again. When panic
is activated, the alarm will
disarm and doors will unlock (if
remote controlled door locks are connected).
ARMED
When the 30 sec. arming countdown ends, or
when transmitter button #1 is pressed to arm
the alarm, the siren chirps and parking lights
flash once, and the LED starts
flashing to show the alarm is
armed.
