EnerSys Alpha Micro 100, Installation And Operation Manual

Page: 23 / 88

017-220-J0 Rev C
22
Figure 7 — Wiring the Alpha Micro 100
Dry Contact
Terminal Block
Output Terminal
Block
Input Terminal
Block
From Line
Power
To Load
Dry Contact and
Eithernet Cable
From Utility
7.4 Installing and Wiring the Batteries
WARNING!
Before proceeding, verify the line wire is attached to the line terminal block, the ground
wire is attached to the ground terminal block and the neutral wire is attached to the
neutral terminal block to prevent accidental shock or electrocution. Check this for both
the input 2, and the output terminal blocks. Ensure input breaker is off.
Make sure the battery breaker is OFF before wiring the batteries.
Use caution when handling batteries, ensure that the battery terminals do not touch any
metal parts.