EnerPlex Surfr User Manual Download Page 1

Surfr™ iPhone 6

Battery & Solar Case

 

 Made for:

• iPhone 6 

B.  Operating Instructions

1. Please use the included Micro USB cable to charge the EnerPlex Surfr.  First 

place your phone securely in the EnerPlex Surfr and then connect the battery pack 

to a power source via the USB cable.  The power source will charge the phone 

and the EnerPlex Surfr at the same time.

2. To charge your iPhone with the EnerPlex Surfr, locate the switch at the bottom of 

the case and slide it toward the LEDs. The four LEDs nearest the switch indicate the 

Surfr’s charge level; each LED represents 25% charge. If no blue lights illuminate, 

then the Surfr requires charging.

3. When there is no electrical source available, place the EnerPlex Surfr under the 

sun or very strong light with the solar panel facing upward.  The Red LED light will il-

luminate automatically, indicating the integrated solar panel is charging the EnerPlex 

Surfr battery.  For best solar charging, angle your EnerPlex Surfr towards the sun.

C.  Important Safety Instructions

1. Be cautious of excessive drops, bumps, abrasions, or other impacts to the 

EnerPlex Surfr solar battery case.

2. Do not expose the EnerPlex Surfr to wet or damp conditions.

3. Do not use near or on heat emitting appliances.

4. Do not attempt to open, disassemble, or replace any spare parts in the EnerPlex Surfr.

5. The EnerPlex Surfr may become somewhat warm during charging, this 

is normal.

6. Do not throw away the EnerPlex Surfr unit, please bring used units to your local 

recycling center.

7. The EnerPlex Surfr is not intended for use by young children without supervision. 

A.  Installation

1. Remove the top cover so it does not impede the insertion of the phone

 on its connector

3. Replace the top cover (see attached diagram)

Reviews: