Enerpac EDCH130, Instruction Sheet

Page: 5 / 16

5
2.0 PRODUCT DATA
2.1 Cutter Maximum Capacities
Cutter
Model
No.
Material to be Cut
Material Maximum
Tensile Strength
Material Maximum
Hardness
psi daN/mm 2 Rockwell C
EDCH130
Metal tubes, plate, cables and similar materials
during decommissioning or demolition activities.
94,275 65 41
EDCH145 94,275 65 41
EDCH170 94,275 65 41
NOTICE
Material to be cut must not exceed any of the stated maximum limits shown in this table.
These specifications are independent material limits provided to help prevent premature blade damage. They
should not be considered as an indication of the maximum cutting capacity of the tool.
The tool will not necessarily cut the largest piece of material that will fit between the blades, even if the material
properties are equal to or less than the stated maximum limits.
Cutting performance, including whether a cut can be completed, will depend on the material properties, blade
condition, and the size and shape of the material being cut. If the tool is struggling or failing to make a cut, select
a larger capacity tool.
2.2 Specifications
Cutter
Model
No.
Weight
Max. Hyd.
Operating
Pressure
Ambient
Operating Temp
Hyd.
Pump*
lb Kg psi bar ˚ F ˚ C
EDCH130 25.4 11.5 10,150 700
-40
to
+122
-40
to
+50
External
EDCH145 37.3 16.9 10,150 700
-40
to
+122
-40
to
+50
External
EDCH170 53.4 24.2 10,150 700
-40
to
+122
-40
to
+50
External
Notes:
*
Hydraulic pump sold separately. Special Enerpac pump required. Refer to Section 6.1 for additional information.
Product specifications are subject to change without notice.